PLC-XF1000 Expand Serial Command Functional Specifications27/728.5.7 CF_DLINE CommandCommand “CF_DLINE_%1” [CR]%1“0100-nnnn” ----------- Directly specify setting value of Display Line“nnnn” indicates maximum value, which is current value of (Total Line - Position V).“UP” ------------------- Increment setting value of Display Line by 1“DN” ------------------- Decrement setting value of Display line by 1DetailsSet setting value of Display Line in PC signal (Available only in the normal PowerON status)The value set by this command is not being stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.8 CF_SETPCADJ CommandCommand “CF_SETPCADJ_%1” [CR]%1 “XGA1”, “HDTV1080”, “MODE1” ....................................Etc.“EXT11“~“EXT60“DetailNote1) When “XGA”,”HDTV1080”,”MODE1” is specified in %1, the command is notexecuted.Note2) When “EXTn-EXTnn” (nn represents number) is specified in %1, “EXT” isdisplayed in “SYSTEM” menu (only when Network board is provided).Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal8.5.9 CF_ORGMODE CommandCommand “CF_ORGMODE_%1” [CR]%1When input signal is PC Analog;“VGA1” ------------------------ Specify VGA1“VGA2” ------------------------ Specify VGA2:“XGA1” ------------------------ Specify XGA1:“WXGA3” --------------------- Specify WXGA3“1080I60” --------------------- Specify 1080i60“1080I50” --------------------- Specify 1080i50“1035I” ------------------------ Specify 10350i“720P60” --------------------- Specify 720p60“720P50” --------------------- Specify 720p50“575P” ------------------------- Specify 575p“480P” ------------------------- Specify 480p“575I” -------------------------- Specify 575i“480I” -------------------------- Specify 480i“1080PSF/24” ----------------- Specify 1080psf/24“1080PSF/25” ----------------- Specify 1080psf/25“1080PSF/30” ----------------- Specify 1080psf/30* When input signal is not PC Analog, error code “101” is returned.DetailsAfter “EXT n” is set by PC control command such as CF_FSYNC/CF_TDOTS andCF_SETPCADJ command, specify the signal originated with by issuing thiscommand.This command is used to specify projector internal settings such as whether or notto get PC signal through IP (Available only in the normal Power ON status)Note; To differentiate between 60Hz and 50Hz in 1080i and 720p, “60” or “50” isnecessary to add to the parameter in this command.Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal