PLC-XF1000 Expand Serial Command Functional Specifications35/728.8 Lamp Command8.8.1 CF_LAMPH CommandCommand “CF_LAMPH_%1” [CR]%1 “RSTn” (n=1-2) --------------------------- Reset lamp 1-2 running timeDetails Reset running time of the lamp specified in “n”.(Valid only when it is in the normal Power ON status.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.8.2 CF_LAMPMODE CommandCommand “CF_LAMPMODE_%1” [CR]%1 “FULL” --------------------------- Set lamp mode to 2-lamp (FULL)“HALF” --------------------------- Set lamp mode to 1-lamp (HALF)DetailsSelect Lamp mode. (Valid only when in the normal Power ON status.)The value set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.On Half mode, one lamp with a fewer used-time light automatically.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.8.3 CF_AUTOLAMPCONTRL CommandCommand “CF_AUTOLAMPCONTRL_%1” [CR]%1“NORMAL” --------------------- Set lamp control mode to NORMAL“ECO” --------------------------- Set lamp control mode to ECO“AUTO” -------------------------- Set lamp control mode to AUTODetailsSelect Lamp control mode. (Valid only when in the normal Power ON status.)The value set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]
