PLC-XF1000 Expand Serial Command Functional Specifications56/729.7.13 CR_IDSLOT1 CommandCommand “CR_IDSLOT1” [CR]Details Get ID information on Slot 1.This command is used to recognize the insertedboard and specify the valid Input source.Acceptable “000_%1” [CR]%1“01” --------------- D-sub boardValid Input Source: ANALOG“03” ---------------Network boardValid Input Source: NONE (BLANK)“04” --------------- Component boardValid Input Source: ANALOG, YPBPR“08” --------------- DUAL-SDI boardValid Input Source: SDI1, SDI2“09” --------------- HDCP-DVI boardValid Input Source: DIGITAL, ANALOG, HDCP, SCART“10” --------------- Warp boardValid Input Source: DIGITAL, HDCP“18” --------------- New HDCP-DVI boardValid Input Source: DIGITAL, ANALOG, HDCP, SCART“19” --------------- New Component & Video boardValid Input Source: ANALOG, YPBPR, VIDEO,S-VIDEO“20” ---------------- Wireless movie cardValid Input Source:HD-wireless“30” --------------- On-board(DVI-DSub+D-Sub)Valid Input Source: DIGITAL, ANALOG, HDCP, SCART“42” --------------- On-board(5BNC+S-video)Valid Input Source: ANALOG, YPBPR, VIDEO,S-VIDEO“99” --------------- No board insertedResponseUnacceptable “?” [CR]9.7.14 CR_IDSLOT2 CommandCommand “CR_IDSLOT2” [CR]Details Get ID information on Slot 2. This command is to recognize the inserted slotboard and specify the valid Input source.Acceptable “000_%1” [CR]%1 The same as CR_IDSLOT1ResponseUnacceptable “?” [CR]9.7.15 CR_IDSLOT3 CommandCommand “CR_IDSLOT3” [CR]Details Get ID information on Slot 3. This command is to recognize the inserted slot boardand specify the valid Input source.Acceptable “000_%1” [CR]%1 The same as CR_IDSLOT1ResponseUnacceptable “?” [CR]9.7.16 CR_IDSLOT4 CommandCommand “CR_IDSLOT4” [CR]Details Get ID information on Slot 4. This command is to recognize the inserted slot boardand specify the valid Input source.Acceptable “000_%1” [CR]%1 The same as CR_IDSLOT1ResponseUnacceptable “?” [CR]