Sanyo PLC-XT20K Owner's Manual

Contents

65Maintenance and Filter CleaningWhen the projection lamp of the projector reaches its endof life, the Lamp replacement icon appears on the screenand LAMP REPLACE indicator lights yellow. Replace thelamp with a new one promptly. The timing when the LAMPREPLACE indicator should light is depending on the lampmode.Follow these steps to replace the lamp.ORDER REPLACEMENT LAMPReplacement lamp can be ordered through your dealer. When ordering, give the following information to the dealer.● Model No. of your projector : PLC-XT25, PLC-XT25L, PLC-XT25K,PLC-XT21, PLC-XT21L, PLC-XT20, PLC-XT20LPLC-XT20K● Replacement Lamp Type No. : POA-LMP105 (Service Parts No. 610 330 7329)For continued safety, replace with a lamp of the sametype lamp. Do not drop the lamp or touch the glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the Lamp cover. The inside ofthe projector can become very hot.CAUTIONTurn off the projector and unplug the AC power cord.Let the projector cool for at least 45 minutes.Remove the two (2) screws that secure the lamp. Liftthe lamp out of the projector by using the handle.13Replace the lamp with a new one and secure the two(2) screws. Make sure that the lamp is set properly.Put the lamp cover back and secure it with the screw.4Remove the screw that secures the lamp cover, andthen open the lamp cover.2Connect the AC power cord to the projector and turnon the projector.6 Reset the lamp counter.See “Resetting the Lamp Counter” on the next page.5Lamp ReplacementCAUTIONScrewLamp replacement iconWARNING:TURN OFF THE UV LAMP BEFOREOPENING THE LAMP COVERTop ControlHandleScrewsLAMP REPLACEindicatorLamp cover