13Part Names and FunctionsTo ensure safe operation, please observe the following precautions :● Use two (2) AAA or LR03 type alkaline batteries.● Always replace batteries in sets.● Do not use a new battery with a used battery.● Avoid contact with water or liquid.● Do not expose the remote control to moisture or heat.● Do not drop the remote control.● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.● Risk of an explosion if battery is replaced by an incorrect type.● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.Press the liddownward and slide it.Open the batterycompartment lid.Install new batteriesinto the compartment.Replace thecompartment lid.Two AAA size batteriesFor correct polarity(+ and –), be surebattery terminals arein contact with pins incompartment.1 3Point the remote control toward the projector when pressingthe buttons. Maximum operating range for the remotecontrol is about 16.4'(5 m) and 60 degrees in front of theprojector.Remote Control Battery Installation16.4'(5 m)30°Remote control30°While pressing the MENUbutton, press the IMAGEbutton number of timescorresponding to the remotecontrol code.MENU buttonIMAGE buttonRESET/ON/ALL-OFF switchRemote Control CodeRemote Control Code Number of TimesPressing IMAGEButtonCode 1 1Code Code 3 3Code 4 4Code 5 5Code 6 6Code Code 8 8The eight different remote control codes (Code 1 – Code 8) are assigned to this projector. Switching the remotecontrol codes prevents interference from other remote controls when several projectors or video equipmentnext to each other are operated at the same time. Change the remote control code for the projector first beforechanging that for the remote control. See "Remote control" in the Setting Menu on page 57.While pressing the MENU button, press the IMAGE button number of times corresponding to the remotecontrol code. See the list below.1To initialize the remote control code, slide the RESET/ ON/ALL-OFF switch to RESET, and then to ON. Theinitial code is set to Code 1.Note:When using as a wired remote control while the standby mode is set to “Eco”, the same remote control code should be seton both the projector and the remote control to turn on the projector. (p.55)Remote Control Operating Range