Sanyo PLC-XU116 - 4500 Lumens Owner's Manual

Also see for PLC-XU116: Dimensional drawing Specification sheet Manual Manual Brochure

Contents

8ComplianceThe AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.AC Power Cord for the United States and Canada:AC Power Cord used in the United States and Canada is listed by the UnderwritersLaboratories (UL) and certified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that theplug will fit into the power outlet. Do not try to defeat this safety feature. Should you be unableto insert the plug into the outlet, contact your electrician.GROUNDAC Power Cord RequirementAC Power Cord for the United Kingdom:This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pinface of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of thesame rating, marked thus ASA . If the fuse cover is detachable, never use the plug with the cover omitted. If areplacement fuse cover is required, ensure it is of the same colour as that visible on the pin face of the plug(i.e. red or orange). Fuse covers are available from the Parts Department indicated in your User Instructions.If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.The end of the flexible cord should be suitably prepared and the correct plug fitted.wARNING : A PLUG wITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKETOUTLETThe Wires in this mains lead are coloured in accordance with the following code:Green-and-yellow EarthBlue . . . . . . . . . . . NeutralBrown . . . . . . . . . LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markingsidentifying the terminals in your plug proceed as follows:The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked bythe letter E or by the safety earth symbol or coloured green or green-and-yellow.The wire which is coloured blue must be connected to the terminal which is marked with the letter N orcoloured black.The wire which is coloured brown must be connected to the terminal which is marked with the letter L orcoloured red.wARNING: THIS APPARATUS MUST BE EARTHEDTHE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILy ACCESSIBLEFederal Communications Commission NoticeThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance with theinstructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference willnot occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more ofthe following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes ormodifications should be made, you could be required to stop operation of the equipment.Model Number : PLC-XU116Trade Name : SanyoResponsible party : SANYO NORTH AMERICA CORPORATIONAddress : 21605 Plummer Street, Chatsworth, California 91311Telephone No. : (818)998-7322