Sanyo PLC-XU116 - 4500 Lumens Owner's Manual

Also see for PLC-XU116: Dimensional drawing Specification sheet Manual Manual Brochure

Contents

63The WARNING indicator shows the state of the function which protects the projector. Check the state of theWARNING indicator and the POWER indicator to take proper maintenance.wARNING indicatorThe projector is shut down and the wARNINGindicator is blinking redWhen the temperature inside the projector reaches acertain level, the projector will be automatically shut down toprotect the inside of the projector. The POWER indicator isblinking while the projector is being cooled down. When theprojector has cooled down enough (to its normal operatingtemperature), it can be turned on again by pressing thePOWER ON/STAND-BY button.The projector is shut down and the wARNINGindicator lights redWhen the projector detects an abnormal condition, it isautomatically shut down to protect the inside of the projectorand the WARNING indicator lights red. In this case, unplugthe AC power cord and reconnect it, and then turn theprojector on once again to verify operation. If the projectorcan not be turned on and the WARNING indicator still lightsred, unplug the AC power cord and contact the servicestation.CAUTIONDO NOT LEAVE THE PROJECTOR WITH THEAC POWER CORD CONNECTED UNDER ANABNORMAL CONDITION. IT MAY RESULT INFIRE OR ELECTRIC SHOCK.Maintenance and CleaningTop ControlTop ControlNote:The WARNING indicator continues to blink even after thetemperature inside the projector returns to normal. Whenthe projector is turned on again, the WARNING indicatorstops blinking.Then check the matters below:– Did you provide appropriate space for the projector to beventilated? Check the installing condition to see if the airvents of the projector are not blocked.– Has the projector been installed near an Air-Conditioning/Heating Duct or Vent? Move the installation of theprojector away from the duct or vent.– Are the filters clean? Clean the filters periodically.WARNING emit ared lightWARNING blinking red