Sanyo PLC-XU116 - 4500 Lumens Owner's Manual

Also see for PLC-XU116: Dimensional drawing Specification sheet Manual Manual Brochure

Contents

14Part Names and FunctionsSpotlightPointer FunctionPointerLaser Pointer FunctionLASER buttonPRESENTATION POINTERbuttonThis remote control emits a laser beam from the laser light window. Press the LASER button to activate thelaser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button ispressed for more than one minute or if it is released, the laser light goes off.The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself orother people. The following is the caution label for the laser beam.CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein mayresult in hazardous radiation exposure. Never look directly into the laser light window while a laseris emitted, otherwise eye damage may result.The caution label is put on the remote control.You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of theprojected image.Press and hold the MENU and the NO SHOW buttonsfor more than 5 seconds to activate the Pointer function.(The Laser pointer has switched to the Pointer function.)1Press the LASER button on the remote controlpointing toward the projector. The Spotlight or Pointeris displayed on the screen with the LASER buttonlighting green. Then move the Spotlight or Pointer withthe PRESENTATION POINTER button. If the LASERbutton does not light green and continues to emit alaser beam, try the abovementioned procedure untilthe LASER button lights green.To clear the Spotlight or Pointer out the screen, pressthe LASER button pointing toward the projector andsee if the LASER button lighting is turned off.To switch to the Laser pointer again, press and holdthe NO SHOW and MENU buttons for more than 5seconds or slide the RESET/ON/ALL-OFF switch toRESET and then to ON.When you reset the Pointer function, the remotecontrol code will be reset, as well.3Note:You can choose the size of Spotlight (Large/Middle/Small) and the pattern of Pointer (Arrow/Finger/Dot) inthe Setting Menu. See “Pointer” on page 54.After the Laser pointer hasswitched to the Pointer, usethe LASER button as thePointer function ON-OFFswitch. Press the LASERbutton pointing toward theprojector and see if it lightsgreen.Laser Light WindowSignal Emission IndicatorMENU buttonNO SHOW buttonPress and hold the MENUand NO SHOW buttons formore than 5 seconds.PRESENTATION POINTERbutton