68Problem: – Solutions– Plug the power cord of the projector into the AC outlet.– See if the POWER indicator lights red.– Wait until the POWER indicator stops blinking to turn on the projectoragain. The projector can be turned on after the POWER indicatorturns red. See page 21.– Check the WARNING indicator. If the WARNING indicator lights red,projector can not be turned on. See page 63.– Check the projection lamp. See page 66.– Unlock the Key lock function for the projector. See page 58.– Make sure Off or Countdown off is not chosen at displayfunction. See page 51.– Make sure User or Off is not chosen at Logo (select)function. See page 51.– Make sure Input search function is adjusted properly. See page 49.– That is the Filter warning icon. See page 61.– That is the Lamp replacement icon or the Filter warning icon. Seepages 60, 61.– Adjust focus of the projector. See page 26.– Provide proper distance between the projector and the projectionscreen. See page 16.– Check the projection lens to see if it needs cleaning. See page 65.– Moving the projector from a cool to warm place may result inmoisture condensation on the projection lens. In such cases, leavethe projector off and wait until condensation evaporates.– Check the Ceiling/Rear function. See page 54.– Check the Ceiling function. See page 54.– Check if the Contrast or Brightness are adjusted properly. Seepages 38, 45.– Check if Image mode is selected properly. See pages 37, 44.– Check the lamp control function. See pages 29, 57.– Check the LAMP REPLACE indicator. If it lights, the end of lamp lifeis approaching. Replace the lamp with a new one promptly. See page66.AppendixTroubleshootingBefore calling your dealer or service center for assistance, check the items below once again.–Make sure you have properly connected the projector to peripheral equipment as described on pages 17-19.–Make sure all equipment is connected to AC outlet and the power is turned on.–When the projector does not project an image from the connected computer, restart the computer.No powerThe initial display is not shownThe initial display is not sameas the default setInput signal switches automatically(or does not switch automatically)when the projector is on and youpress the input button, an iconother than the Lamp mode iconappears.An icon other than Input mode orLamp mode icon appearsImage is out of focusImage is Left/Right reversedImage is Top/Bottom reversedPicture is not bright enough