Sanyo PLC-XU88 Owner's Manual

Also see for XU88 - PLC XGA LCD Projector: Owner's manual Owner's manual Specification sheet Specification sheet Specification sheet

Contents

10Part Names and FunctionsRear Terminal⑤ S-VIDEO INConnect the S-VIDEO output signal from videoequipment to this jack (p.19).⑥ AUDIO INConnect the audio output signal from videoequipment connected to ⑤ or ⑫ to this jack. For amono audio signal (a single audio jack), connect itto the L (MONO) jack (p.19).⑪ COMPUTER/COMPONENT AUDIO INConnect the audio output (stereo) signal from acomputer or video equipment connected to ③ or④ to this jack (pp.18, 20).⑫ VIDEO INConnect the composite video output signal tothis jack (p.19).④ COMPUTER IN 2/COMPONENT IN/ MONITOROUTThis terminal is switchable and can be used forinput from a computer or output the incoming RGBanalog signal from COMPUTER IN1 terminal to theother monitor.Set the terminal up as either Computer input orMonitor output properly. (Used for Monitor out,this terminal outputs only incoming signal fromCOMPUTER IN 1 terminal.) (pp18,20)⑦ AUDIO OUT (VARIABLE)Connect an external audio amplifier to this jack(pp.18–20).This terminal outputs sound from AUDIO INterminal (⑥ or ⑪).② SERVICE PORTThis jack is used to service the projector.③ COMPUTER IN 1/DVI-IConnect computer output (Digital/Analog DVI-Itype) to this terminal (p.18).⑧ LAN Connection TerminalConnect the LAN cable (refer to the owner’smanual “Network Set-up and Operation”).① USBIn order to operate the computer with the remotecontrol and use the PAGE ▲▼buttons on theremote control during a presentation, connect theUSB port of the computer to the USB terminal with aUSB cable (not supplied) (pp.12, 18).⑨ SD Card SlotInsert the SD card memory (not supplied) forMemory viewer operation(refer to the owner'smanual of Memory viewer).② ③① ⑤ ⑥④ ⑦ ⑧⑨⑩⑪⑫⑩ SD Card IndicatorDisplay the status of SD card. When insertingSD Card, the indicator lights, and whenunplugging SD Card, the indicator turns off.