0Computer InputChoose Computer 1(Digital) by pressing the INPUT buttonon the top control or press the COMPUTER button on theremote control.Before using these buttons, correct input source should beselected through Menu operation as described below.Press the MENU button to display the On-ScreenMenu. Use the Point ◄► buttons to move the redframe pointer to the Input Menu icon.1Input MenuUse the Point ▲▼ buttons to move the red arrowpointer to Computer 1 (Digital), and then press theSELECT button.After the Source Select Menu appeared for Computer 1(Digital), move the pointer to RGB (PC digital) or RGB(AV HDCP), and then press the SELECT button.Input Source Selection (RGB(PC digital), RGB(AV HDCP))Move the pointer( r e d a r r o w ) t oComputer 1 (Digital)a n d p r e s s t h eSELECT button.Input Menu iconMove the pointer tothe source that youwant to select andpress the SELECTbutton.Computer1Computer 1 (Analog)VideoComputer COMPUTER buttonwiredTop Control INPUT buttonComputer 1 (Digital)Remote ControlComputer 1 (Analog)Computer Computer 1 (Digital)Direct OperationMenu OperationNotes:• HDCP (High-bandwidth Digital Content Protection) isa system for protecting digital entertainment contentdelivered by DVI (Digital Visual Interface) from beingcopied. The specification of HDCP is decided andcontrolled by Digital Content Protection, LLC. Should thespecification be changed, this projector may not displaythe digital content protected by HDCP.• Wired and Wireless are for the Network function. Seeowner’s manual “Network Set-up and Operation” .• When the Input Search function is set to “On1” or “On2”,the input signal will be searched automatically (p.50).• When Monitor out is selected in the Terminal function(p.50), Computer 2 is not displayed.wireless