9Choose either Computer 1 (Analog) or Computer 2 bypressing the INPUT button on the top control or press theCOMPUTER button on the remote control.Before using these buttons, correct input source should beselected through Menu operation as described below.Press the MENU button to display the On-ScreenMenu. Use the Point ◄► buttons to move the redframe pointer to the Input Menu icon.1 Input MenuUse the Point ▲▼ buttons to move the red arrowpointer to either Computer 1 (Analog) or Computer 2,and then press the SELECT button.When selecting Computer 1 (Analog), RGB inputsource will be selected directly.When selecting Computer 2, the Source Select Menuappears. Move the pointer to RGB and then press theSELECT button.Computer 1 (Analog)VideoComputer Input Source Selection (RGB: Computer 1 (Analog)/Computer )Computer InputMove the pointer (redarrow) to Computer 1(Analog) and press theSELECT button.Input Menu iconCOMPUTER buttonNotes:• Wired and Wireless are for the Network function. Seeowner’s manual “Network Set-up and Operation” .• When the Input Search function is set to “On1” or “On2”,the input signal will be searched automatically (p.50).• Computer 2 is not displayed when the COMPUTER IN 2/MONITOR OUT terminal is set as Monitor out. (p.50)• Computer 2 (COMPUTER IN 2/MONITOR OUT) canaccept only RGB signal.Move the pointer(red arrow) to RGB.Move the pointer (redarrow) to Computer 2and press the SELECTbutton.Input Menu iconComputerwiredTop Control INPUT buttonComputer 1 (Digital)Remote ControlComputer 1 (Analog)Computer Computer 1 (Digital)Direct OperationMenu OperationInput Menuwireless