Sanyo XC50 - PLC XGA LCD Projector Owner's Manual

Also see for PLC-XC50A: Specification sheet Dimensional drawing

Contents

4To the OwnerCAUTION: TO REDUCE THE RISK OF ELECTRICSHOCK, DO NOT REMOVE COVER (ORBACK) NO USER-SERVICEABLE PARTSINSIDE EXCEPT LAMP REPLACEMENTREFER SERVICING TO QUALIFIEDSERVICE PERSONNELTHIS SYMBOL INDICATES THAT DANGEROUSVOLTAGE CONSTITUTING A RISK OF ELECTRICSHOCK IS PRESENT WITHIN THIS UNIT.THIS SYMBOL INDICATES THAT THERE AREIMPORTANT OPERATING AND MAINTENANCEINSTRUCTIONS IN THE OWNER'S MANUALWITH THIS UNIT.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENBefore installing and operating this projector, read thismanual thoroughly.This projector provides many convenient features andfunctions. Operating the projector properly enablesyou to manage those features and maintains it in goodcondition for many years to come.Improper operation may result in not only shortening theproduct-life, but also malfunctions, fire hazard, or otheraccidents.If your projector seems to operate improperly, read thismanual again, check operations and cable connectionsand try the solutions in the “Troubleshooting” sectionin the back of this manual. If the problem still persists,contact the dealer where you purchased the projector orthe service center.Safety PrecautionCAUTIONDO NOT SET THE PROjECTOR IN GREASy, wET, ORSMOKy CONDITIONS SUCH AS IN A KITCHEN TO PREVENTA BREAKDOwN OR A DISASTER IF THE PROjECTORCOMES IN CONTACT wITH OIL OR CHEMICALS, IT MAyBECOME DETERIORATEDREAD AND KEEP THIS OwNER'S MANUAL FORLATER USEwARNING: ● THIS APPARATUS MUST BE EARTHED● TO REDUCE THE RISK OF FIRE ORELECTRIC SHOCK, DO NOT EXPOSE THISAPPLIANCE TO RAIN OR MOISTURE–This projector produces intense light from the projectionlens. Do not stare directly into the lens, otherwise eyedamage could result. Be especially careful that childrendo not stare directly into the beam.–Install the projector in a proper position. Otherwise it mayresult in fire hazard.–Allowing the proper amount of space on the top, sides,and rear of the projector cabinet is critical for properair circulation and cooling of the unit. The dimensionshown here indicate the minimum space required.If the projector is to be built into a compartment orsimilarly enclosed, these minimum distances must bemaintained.–Do not cover the ventilation slot on the projector. Heatbuild-up can reduce the service life of your projector, andcan also be dangerous.–If the projector is unused for an extended time, unplugthe projector from the power outlet.–Do not project the same image for a long time. Theafterimage may remain on the LCD panels by thecharacteristic of panel.SIDE and TOP REARCAUTIONNot for use in a computer room as defined in the Standardfor the Protection of Electronic Computer/Data ProcessingEquipment, ANSI/NFPA 75.0.7’(20cm)1.5’(50cm) 3’(1m) 3’(1m)20cm50cm 1m 1mFOR EU USERSThe symbol mark and recycling systems described belowapply to EU countries and do not apply to countries in otherareas of the world.Your product is designed and manufactured with high qualitymaterials and components which can be recycled and/orreused.The symbol mark means that electrical and electronicequipment, batteries and accumulators, at their end-of-life,should be disposed of separately from your household waste.Note:If a chemical symbol is printed beneath the symbol mark,this chemical symbol means that the battery or accumulatorcontains a heavy metal at a certain concentration. This willbe indicated as follows: Hg: mercury, Cd: cadmium, Pb: leadIn the European Union there are separate collection systemsfor used electrical and electronic equipment, batteries andaccumulators.Please, dispose of them correctly at your localcommunity waste collection/recycling centre.Please, help us to conserve the environment welive in!