Sanyo XC50 - PLC XGA LCD Projector Owner's Manual

Also see for PLC-XC50A: Specification sheet Dimensional drawing

Contents

45SettingNote:• Auto Keystone corrects vertical distortion only,not correct horizontal distortion.• The Auto Keystone function cannot work whenthe Ceiling feature is set On in the Setting menu(p.50).• Perfect correction of the image distortion cannotbe ensured with the Auto setup function. If thedistortion is not corrected properly by pressing theAUTO SETUP or the AUTO SET button, adjustmanually by pressing the KEYSTONE button onthe remote control or selecting Keystone in theSetting menu (pp.23, 46).• Fine sync, Total dots, Horizontal and Verticalposition of some computers cannot be fullyadjusted with the Auto PC Adjustment function.When the image is not provided properly withthis operation, manual adjustments are required(pp.31-32).This function detects the input signal automatically. Whena signal is found, the search will stop. Use the Point ▲▼buttons to select one of the following options.Off ........... Input search will not work.On1.......... Input search works under the following situation.– When pressing the AUTO SETUP button onthe top control.– When pressing the AUTO SET button on theremote control.On.......... Input search works under the following situation.– When turning on the projector by pressing theON/STAND-BY button on the top control or theremote control.– When pressing the AUTO SET button on theremote control.– When pressing the AUTO SETUP button onthe top control.– When the current input signal is cut off.** If the No show or Freeze function is active, cancel it toactivate the Input search. It is also unavailable when On-Screen menu is displayed.Auto setupNote:• While Input search is set to On1 or On, the status of Inputand Lamp are displayed every time the signal is switched.• Only the last selected input source can be detected.• During Input search is in progress, if the INPUT button onthe top control, the COMPUTER1/2 button, the S-VIDEObutton, the COMPONENT button or the VIDEO button onthe remote control, the MENU button or the ON/STAND-BYbutton is pressed, Input search will stop. If the INPUT buttonis pressed, the Input search will go back to the current seachsignal. If the COMPUTER 1/2 button or VIDEO or S-VIDEO orCOMPONENT button is pressed, Input search will go back tothe button's input signal.• Input search, Auto PC adj and Auto Keystone cannot beset Off at the same time.This function enables Input search, Auto Keystone correctionand Auto PC adjustment by pressing the AUTO SETUP buttonon the top control or the AUTO SET button on the remotecontrol. Settings for those functions can be altered as follows:Closed captionAuto setupInput searchAuto . . . . . Always works and corrects keystone distortionaccording to the projector's tilt.Manual . . . . Works only when pressing the AUTO SETUPbutton on the top control or the AUTO SETbutton on the remote control.Off . . . . . . . Disables Auto Keystone.Auto PC adjOn. . . . . . . . Enables Auto PC Adjustment when pressingthe AUTO SET button on the remote control orthe AUTO SETUP button on the top control.Off . . . . . . . Disables Auto PC Adjustment.Auto Keystone