148 Part H: Diagnosing MB8100-00-00-806 © TEL 2003System TestsThe Service Kit can initiate self-tests on the base station you are logged on toand verify that the control panel controls are working.Self-TestsIn the Self Tests form (Diagnose > System > Self Tests), you can ask the basestation to carry out a set of self-tests. The base station itself determines whetherit passes a test. The form displays the result of those tests.You can use the option buttons to configure the display to show all test results,only tests that failed, or only tests that passed.To run base station self-tests1. Click Run Tests. The tests can take up to 90 seconds. When the tests arecompleted, the Self Tests form displays the results.2. If the base station fails a test, click Reset Base Station (Administrator accesslevel required). This may enable the base station to recover. You need toconnect the Service Kit again and log on to the base station.3. Click Run Tests again. If the base station still does not pass the tests, noteany failure codes displayed in the Code column and send the base station forrepair.
