74 Part E: Configuring the Base Station MB8100-00-00-806 © TEL 2003Configuring General OptionsThe General form (Configure > Base Station > General) names the base stationand specifies the default channel. From this form, you can customize the defaultchannel and signalling profiles. A panel on the right gives you high-levelinstructions on how to configure channels in a simple system.Identification Specifies the name of the base station. Enter a suitable name. This name is usedin the Log On form to help you select the correct base station within the BSS.You may need to disconnect and turn the base station off, and then turn thebase station on again and re-connect, before a new name appears in the log onwindow and on the status bar.Default profiles Lets you configure default profiles. Click Channel Profile or Signal Profileto open the editing dialog box for the corresponding default profile.Default channel Specifies the default channel. Select a channel from the drop-down list to makeit the default channel (see “Default Channel” on page 5). The drop-down listcontains all the channels that have been defined in the channel table (Configure> Base Station > Channel Table). Each entry in the list contains a channelnumber followed by the corresponding channel name.
