Ethernet Params119Ethernet ParamsEthernetParams(from page 117)* = Factory DefaultASCIIData PortEthernetSpeed9100*1025 - 65535Auto Select*10 Half Duplex10 Full Duplex100 Half Duplex100 Full DuplexKeep AliveTimer3 Minutes*0 - 10 MinutesJob ControlStandard*EnhancedFast StandardOffOfflineProcessDisable*EnableThe Ethernet Params menu helps your printer communicate on a network.ASCII Data PortThis option sets the port number for ASCII print jobs. The data port numberneeds to match your host system setting.• 9100 (default)• 1023 - 65535Keep Alive TimerThis is the time that the Keep Alive Timer will run. With the Keep Alive Timeron, the tcp connection will stay connected even after the print job hasterminated.• 3 Minutes (default)• 2 - 10 MinutesEthernet SpeedThis menu option only appears if a 10/100Base-T network interface card(NIC) is installed. The Ethernet Speed menu allows compatibility with differentsystems and networks. The factory default is Auto Select.• Auto Select. (default) This setting tells the 10/100Base-T NIC to performan auto detection scheme and configure itself to be 10 Half Duplex, 10Full Duplex, 100 Half Duplex, or 100 Full Duplex.• 10 Half Duplex. Tells the 10/100Base-T NIC to communicate at 10Megabits per second using half duplex.• 10 Full Duplex. Tells the 10/100Base-T NIC to communicate at 10Megabits per second using full duplex.• 100 Half Duplex. Tells the 10/100Base-T NIC to communicate at 100Megabits per second using half duplex.• 100 Full Duplex. Tells the 10/100Base-T NIC to communicate at 100Megabits per second using full duplex.
