94Chapter 4 Config MenuWith "Bold" selected, bolding is accomplished by rendering the boldedcharacters twice, one with a small offset to create a "shadow" effect. Theresulting print is thicker and thus appears darker. This is the same techniqueused with the "bold" character attribute selected via emulation escapesequences.Form Feed at TOFThis parameter dictates how the printer will respond to a Form Feed ControlCode received from the host computer when it is already at a top-of-formlocation.• Enable (default). The printer performs the requested form feed andadvances to the next top-of-form.• Disable. The printer ignores the Form Feed Control Code sent from thehost.ESCThis parameter is valid only in the Tally ANSI and LG01 emulations. When setto Disabled, the ESC control character is ignored. The default is Enable.Alt ESC (Alternate Escape)This parameter is only valid in the Tally ANSI and LG01 emulations. When setto Enabled, a "^" (carat) character in column 1 (left margin) followed by a CRor a CR LF can be used in place of the ESC control code. The default isDisable. ESC (see above) must also be Enabled for this to work.Upper OnlyThis parameter allows you to set up your printer to print in uppercasecharacters only from the active Character Set. When this parameter isenabled, the lower-case characters in Hex positions 61 through 7A areoverwritten by the uppercase characters in positions 41 through 5A. Thedefault is Disable.Code 7FThis parameter allows you to dictate how the printer will react when it receivesa Hexadecimal code 7F. The default value depends on the emulation.(See the Emulation Parameter, page 70.).• Ignore. The code is ignored.• Delete Char (default). The previous character is deleted.• Delete Buffer. The previous characters on the current print line aredeleted.• Space. A Space character is substituted.• Fill. A Fill character is substituted.
