Set the Tear Bar Distance207Set the Tear Bar DistanceTo set the tear bar distance, do the following steps:1. Make sure the printer is offline.2. Press ENTER key to enter Menu mode.3. Press the right arrow until the Config Menu icon is highlighted.4. Press ENTER to go into Config Menu.5. Press the down arrow until “ZTP SETTINGS” is highlighted.6. Press ENTER to go into the “ZTP SETTINGS” submenu.7. Press the down arrow until “ZTP TearDistance” is highlighted.8. Press the left arrow or right arrow to decrease or increase the tearbar distance in increments of 1/144th of an inch.9. Press ENTER to select the desired value. An asterisk appears next theselected value and a scale prints to indicate the tear bar distance inrelation to the tear bar. For correct tear bar distance, the zero should alignwith the tear bar. See Figure 51.NOTE: The Tear Distance value must be changed to print the scale.Figure 51. Correct Tear Bar DistanceNOTE: When a new ZTP Tear Bar Dist value is selected, the printer will losethe current print position until you reset the top of form toautomatically save the new value.10. Reset the top of form using the procedure on page 208.+50-500Print StationCorrectTearBarDistancePhysical TearBarPosition
