Codes Submenu95Print 80 - 9F HexThis parameter defines whether locations 80 through 9F Hex are to be treatedas control characters or printable characters. The function of the controlcharacters in this area depends on the emulation. The selections are ON(printable characters) or OFF (control characters). The default value dependson the emulation.Ignore CharThis parameter allows you to select a character that will be ignored in theincoming data stream. This parameter functions in all emulations andnon-downloadable print modes. It does not function in plot mode, fontdownload, or VFU download. Selections are 0-255, referring to the decimalvalue of any 8-bit character, or OFF. Default is OFF.Sub Char FromThis parameter allows you to select a character that will be replaced by thecharacter designated by the Sub Char To parameter. This parameterfunctions in all emulations and non-downloadable print modes. It does notfunction in plot mode, font download, or VFU download. Default is OFF.Sub Char ToThis parameter allows you to select the character that will replace thecharacter designated by the Sub Char From Parameter. This parameterfunctions in all emulations and non-downloadable print modes. It does notfunction in plot mode, font download, or VFU download. Default is OFF.PTX SFCCDefines the Special Function Control Character used by the Printronix P5000emulation. The decimal value of the ASCII character code is entered. Thedefault value is 1 (SOH).PTX ALSDefines the single line Alternate Line Spacing used by the ACK (Hex 06)command in the Printronix P5000 emulation. The possible selections are 8 or10.3 which define the line density. The default value is 8.NOTE: The PTX SFCC and PTX ALS options will only appear if the PrintronixP5000 emulation is selected with the Ser/Par Emul control paneloption.TOF Control(Available when Genicom ANSI emulation is selected)When a new form is defined, the top-of-form position is left unchanged if thisparameter is set to Enable (the default). When a new form is defined, and thisparameter is set to Disable, the top-of-form position is reset to the top marginof that form.
