User guide The control panel23Setup mode In this mode, the following settings are available:` Setup key: Sets the printer to setup mode, in which the followingsettings can be selected:` Menu key (1): Other menu settings. Acces may be disabled bythe manufacturer (see note below).` Adjust key (2): Sets the Tear position, first printing line and printhead gap.` Paprpath key (3): Sets the Paper path.` Char key (4): Sets the font and number of characters per inch.Access to the other menu settings (Menu) may be – dependingon the model – disabled by the manufacturer.Proceed as follows to release this lock temporarily.1 Switch off the printer for approx. 5 seconds.2 Switch the printer on again keeping the Setup key pressed untilSelftest disappears on the display.For information on how to enable access permanently andabout the available settings, refer to the section Menu lock(MenLock) (page 56) and Menu parameters (page 45).The settings for Font and CPI are lost when the printer isswitched off. The section Selecting font (Font) (page 47) andSetting character density (CPI) (page 60) explains how to setfonts and character density permanently.Adjust PaprpathMenu Char OnlineSetup21 3 4
