User guide Settings35SettingsThis section describes how to set the tear position, the first printingline, the print head gap as well as the font and the character density.Setting the tearpositionIf the tear position of the paper is not aligned with the tear edge ofthe printer, you can adjust it. Inserted paper needs to be torn off ifnecessary and retracted to park position.Press the Setup key. The printer changes to setup mode.Press the Adjust (2) key.Press the Tear (4) key.Swing the soundproofing cover towards the front (see Printer at aglance, page 3). The tear edge is located at the front side of the pa-per output opening.Press the < (2) or > (3) key to move the perforation to the desiredposition. Confirm the input by pressing the Set (1) key. Confirm theinput again by pressing the Setup key. The printer is reset to the in-itial status.The correction made – a maximum of approx. 1" (2.5 cm) ineach direction – will be retained after switching the printer off.It can be set separately for each paper path.Make sure that the set form length corresponds to the actuallength of the forms you are using.7Adjust PaprpathMenu Char OnlineSetup21 3 4TOFHead Tear OnlineSetup21 3 4TearAdj= 00/72"*Set < > Exit OnlineSetup21 3 4
