User guide Settings36Setting the first printingline (TOF)You can use the TOF function for setting the position of the first prin-ting line for each paper source and each menu individually.Before using the TOF function (if fanfold paper is used), youshould first set the tear position; see Setting the tear position(page 35).Swing the soundproofing cover towards the front (see Printer at aglance, page 3).Press the Setup key. The printer changes to setup mode.Press the Adjust (2) key.Press the TOF (3) key.The paper is fed to the position where the bot-tom edge of the first printing line A is alignedwith the tear edge B of the printer. The factorysetting for the first printing position (TOF) is12/ 72" (4.23 mm). This is equivalent to the se-cond line from the top.Press the < (2) or > (3) key to move the first printing line to the desi-red position. You can set values from 0 to 220/72" for fanfold paperor for single sheets.Confirm the input by pressing the Set (1) key. Press the Setup key.The printer returns to the initial status.The selection made will be retained after switching off theprinter.Adjust PaprpathMenu Char OnlineSetup21 3 4TOFHead Tear OnlineSetup21 3 4C o m p u te rd ru c k e r Computerdrucker ABFormAdj= 12/72"*Set < > Exit OnlineSetup21 3 4
