User guide Paper handling26Paper handlingThis section describes how to set the paper type, load fanfold paperand single sheets, transport paper and move the paper to the tearposition.Changing the paperpathYou can change the paper type either from an application program,by means of the paper path quick selection feature or in the Setupmenu. In this section, the quick selection feature is described; for de-tailed information on how to make this setting via the Setup menu,refer to the section Setup mode (page 23).Make sure that the printer is in offline mode (Pause); press the On-line key, if necessary.Press the Park (1) key. If fanfold paper is loaded in the printer, it isfed to the tear position. The text Tear paper off appears in the dis-play.After having torn off the paper, press any key. If a single sheet isloaded in the printer, it is ejected.Use one of the marked keys to select the desired paper path, for ex-ample, Single (2).The display shown here may vary depending on whichpaper options you have installed.If you do not make a selection within 5 seconds, themenu is closed.The display alternates between the basic menu and the menu in thefollowing figure:Insert a single sheet (for the procedure, see Loading paper(page 28).Press the Online key to set the printer to ready status. When theprinter receives data from the computer, the single sheet is automat-ically loaded. Press the Load (4) key to load the single sheet beforestarting the printout.6Pause Front1Park LF/FF OnlineSetup21 3 4Single Front1OnlineSetup21 3 4Load paper fromSingle OnlineSetup21 3 4Ready SingleM1 EPS Load OnlineSetup21 3 4
