User guide The control panel24Messages in the LCdisplayIf the printer detects an internal fault or user error or if it expects youto do something, a message will appear in the LC display. It also dis-plays the status during an operation (e.g. Loading default). Belowyou will find a list of messages with brief descriptions of each mes-sage. The messages are described in greater detail in the chapterError messages via the display (page 101).Message MeaningEject error The printer cannot eject the paper /advance it to park position.Hardware Alarm Internal hardware error, contact yourdealer or service technician.Head hot The printer reports that the print head ishot and that print speed will be reduced.Initializing This message appears during theprinter’s initializing phase.Load error The printer cannot draw in the loadedpaper.Loading default Indicates that the printer is being initia-lised and is carrying out the internal self-test immediately after turning on theprinter. Factory defined parameters willbe reloaded in all available menues.Out of paper The printer has detected paper end dur-ing operation / printer was switched onwith no paper loaded.Parity error A parity error during data transmission isindicated.Press any key The user is requested to press any key.Tear Paper off The user is requested to tear off paperwhich has been advanced to the quicktear edge.Selftest After power-on, the printer executes ashort hardware self-test.
