DM-3200 Release Notes6 TASCAM DM-3200 Release NotesVersion 1.30ª IF-FW MKII supportTDIF Hi-Speed supportWhen operating at a high sampling rate (88.1k/96kHz),the high speed mode of TDIF-1 connectors 1-3 and theseparately sold IF-TD/DM option card are now supported.Even when operating at a high sampling rate, one TDIF-1connector can transfer eight channels of digital audio I/O,and when the IF-TD/DM is used in conjunction with theX-48, a maximum of forty channels of digital audio I/Ocan be transferred.TDIF-1 1-3•Figure 6 DIGITAL>FORMAT screenIn the DIGITAL>FORMAT screen TDIF I/O Tx/Rx MODEsection, you can now switch between high speed and dualline for TDIF-1 connectors 1-3. This selection will switchall three of the TDIF-1 connectors.When using high speed operation, the 8 I/O setting willbe available for TDIF input/output in the ROUTING screen;when using dual line, only the 4 I/O setting will be available.IF-TD/DM•Figure 7 DIGITAL>SLOT screenAn indication of HI-SPEED is shown in the TDIF-1 Cardscreen of the DIGITAL>SLOT screen.IF-TD/DM supports only high speed; it does not supportdual line.ª MIDIMIDI control change message support formixer parametersMIDI control change messages are now supported, allow-ing mixer parameters (FADER, PAN, and MUTE) to becontrolled.This allows MIDI devices to be controlled in synchroniza-tion with operations on the DM-3200 mixer, or converselyfor mixer parameters to be controlled from a MIDI device.In the MIDI>CtrlChg MIX. screen, the CONTROL CHANGE TABLEFOR MIXER allows you to assign control change numbers.Figure 8 MIDI>CtrlChg MIX screenBy using BATCH SETUP you can make settings for allsixteen channels at once.MIDI>SETUP screen filteringIn conjunction with MIDI control change support for mixerparameters, filtering has been added to the USB MIDI 4:PC/CC port.Figure 9 MIDI>SETUP screenUntil now, the input/output on/off setting for USB MIDI port3 (used for MIDI time code) had been a single setting forinput and out put, but these can now be set independently.