DM-3200 Release Notes8 TASCAM DM-3200 Release NotesMeter over-level settingsIn the METER/FADER>METER screen, you can now makefine adjustments to the point at which the over-level indica-tor will light in order to match other equipment present inyour system.Figure 12 METER/FADER>METER screenUse the POD 2 knob to select one of the following as thepoint at which the over-level indicator will light.-0.20, -0.17, -0.13, -0.10, -0.06, -0.03Cursor location when a multi-control screen isdisplayedThe cursor location will now move to the module selectedby the SEL key when you display a multi-control screensuch as the AUX1-2 screen.MUTE Clear function has been addedBy holding down the SHIFT key or CTRL key and press-ing a MUTE key, you can now defeat muting for all chan-nel modules.SHIFT key + MUTE key: Defeat muting for the currentlyselected channel layerCTRL key + MUTE key: Defeat muting for all channel layersThis function does not work for master modules such asBUSS, AUX, or STEREO.NOTESolo can be cleared in a similar way.ª Automation WR-RHS indication has beenaddedWhen you write the current channel during an automationwrite rehearsal, the automation status area in the upper partof the LCD will now indicate [WR-RHS], indicating thatrehearsal is occurringª About remote controlUse P2 protocol to remotely control the X-48You can now use P2 protocol to control the transport of theX-48.In the supported devices area of the REMOTE>MACHINECTRL screen, choose MM/MX-24/X-48.Figure 13 REMOTE>MACHINE CTRL screenYou can specify 1-48 as the REC Function.Scrolling indicators for the supported devicelist in the machine control screenIf the list of supported devices in the right side of themachine control screen does not fit in the screen, arrowswill appear at the top and bottom.MMC command type addedThe commands transmitted from the DM-3200 when youperform a JOG operation can now be matched to the devicebeing controlled. You can choose either Search (46h) orStep (48h). For details, refer to the operating manual of thedevice you are controlling.This setting is made in the REMOTE>MC SETUP screen’sMMC Command Type area.Figure 14 REMOTE>MC SETUP screenTransmission of locate commands when edit-ing a locate pointWhen you use the EDIT key located in the MACHINECONTROL section of the top panel to ENTER or edit a locatepoint, a LOCATE command is now transmitted when youpress the ENTER key to store the memory.This allows you to locate a connected device at the sametime that you edit the locate point.FireWire card support.