2 – Basic operational concepts : Copy and paste of parametersTASCAM DM-4800 User’s Manual 29Copy and paste of parametersThese operations can be carried out, whether or notthe “fat channel” controls described above have beenused to make the settings.To copy channel parameters Press and holdthe COPY key, and press the SEL key of the channelfrom which the copy is to be made. A popup messageappears to say that the parameters have been copied.To paste channel parameters Press and holdthe PASTE key, and press the SEL key of the channelto which the parameters are to be copied.Press ENTER to paste the parameters (including pan,buss assignment, etc.) into the destination channel, orany cursor key to cancel the operation.To paste only the gate parameters Pressand hold the PASTE key, and the GATE ON keytogether, and press the SEL key of the channel towhich the gate parameters are to be copied.Press ENTER to confirm the operation, or a cursorkey to cancel it.To paste only the compressor/expanderparameters Press and hold the PASTE key,and the COMP/EXP ON key together, and press theSEL key of the channel to which the compressor/expander parameters are to be copied.Press ENTER to confirm the operation, or a cursorkey to cancel it.To paste only the EQ parameters Press andhold the PASTE key, and the EQ ON key together,and press the SEL key of the channel to which theequalization parameters are to be copied.Press ENTER to confirm the operation, or a cursorkey to cancel it.Nothing happens if you try to paste inappropriate set-tings to the “wrong” channel (e.g. equalization set-tings have no meaning if pasted to an Aux master). Ifyou are pasting all the channel settings that can bemade using the “fat channel”, though, those whichare applicable to the destination channel will bepasted.The SCREEN key The SCREEN key in the EDITPARAMETERS section is used to jump to the chan-nel parameter copy screen (see “UTILITY copying”on page 30 below).Figure 2.23: PARAMETER EDIT in the “fat channel”Figure 2.24: Pasting channel parameters
