Tascam DR-100 Owner's Manual

Also see for DR-100 MKIII: Guide to using Comparison chart Owner's manual Service manual Owner's manual

Contents

Tascam DR-100 Owner's Manual Manual pdf 11 page image

TASCAM DR-100 112–Quick Start GuidePrepare to record1 Format the SD card (if necessary).If a new card or one that has not been formattedby this unit is installed, the following messageappears.Press the ENTER/MARK key to start formattingthe card.NOTEThe included SD card is already formatted, so there isno need to reformat it.2 Set the date and time.This unit uses its internal clock to make a recordof the date and time when a file is recorded.You can record without making the setting, butthe unit is set to the default value of "2000/01/0100:00". (See “Setting the date and time” on page21.)3 Set the recording formatSet the recording mode and sampling frequency.(See “Preparing with the REC SETTING menu”on page 25.)If you skip this step, the unit will record with thefollowing default values.Recording mode: WAV 16 bitSampling frequency: 44.1 kHzStart and stop recordingFollow these steps to use the built-in mics (UNIMIC) to record.1 Set the input signal.Move the INPUT switch to UNI.2 Adjust the recording level.Press the RECORD [º] key to put the unit inrecording standby.Adjust the input level using the INPUT volumecontrol and the MIC GAIN switch until the metersshow as much level as possible without causingthe PEAK indicator to light. (See “Adjusting theinput level” on page 27.)3 Record.Press the RECORD [º] key to start recordingfrom recording standby.4 Stop recording.Press the STOP [ª] key to stop recording.For detailed information about recordingmethods and convenient recording functions, see“6–Recording” on page 25.