Tascam US-428 Owner's Manual

Also see for US-428: Supplementary guide Brochure How to install Setup guide Setup guide

Contents

Tascam US-428 Owner's Manual Manual pdf 28 page image

28NOTE: Cubasis supports only one inputfor recording (though this can be amono or stereo track). To fully utilize theUS-428’s four input capabilities, you’llneed to run it with a full version ofCubase VST, Emagic Logic, Cakewalk,or another application that supportsmultiple inputs on record.NOTEThen select the inputs on Cubasis’internal mixer. Hold Control and left clickon the input selector above the channelstrip, and select the desired input. Verifythat the designated channels' inputs("IN") are selected, and the associatedchannels are receiving signal. (seeillustration 6.06)Highlight a track in the arrange window,and that track will automatically beRecord- Enabled. (see illustration 6.07)Verify that the drop-in and drop-outfeatures in Cubasis (on the transportbar) are not enabled (or if so, that theyare enabled at the desired locatepoints). Press the RECORD button onthe US-428. Cubasis will issue a one ortwo bar countoff (depending on what’sset in Cubasis’ Metronome preferencesmenu), then commence recording.6.4 Transport Controls andLocate PointsThe transport controls on the US-428are set up to directly correspond to theon-screen transport controls in Cubasis.So, for example, pressing PLAY on theUS-428 will activate the PLAY mode inCubasis. Pressing STOP will haltplayback on Cubasis. Pressing REW orFFWD will activate Cubasis’ transportsto Rewind or Fast Forward, respectively.The DATA WHEEL, when AUX is notselected, will also act as a shuttle wheelfor the transport. Rotating the wheelclockwise will advance the song positionforward, and rotating it counter-Illustration 6.06 - Input selection window,showing Mutes and SolosIllustration 6.07 - Record Enable