T+A HV Series User Manual

Also see for HV Series: User manual User manual User manual User manual User manual

Contents

T+A HV Series User Manual Manual pdf 57 page image

57The Configuration for a Wired Ethernet LAN or Power-Line LAN connectionSetting the Parameters for aWired Network Connect the SDV 3100 HV to an operational network or Power-Line modemusing the LAN socket on the back panel. Switch the SDV 3100 HV on, Open the System Configuration menu bypressing the  button on the remote control handset or the button on the front panel of the SDV 3100 HV. Use the  /  buttons to select the menu point “Network”, thenconfirm your choice with the  button. If necessary select under the menu item "Interface" the option "LAN" You should now see the menu reproduced below, displaying the networkparameters. You can now select the individual menu points and adjust them to matchyour network conditions. The illustration below shows the possible buttoninputs after each menu item.Possible entries / : Switching ON / OFF(0...9): Numeric input, separating dots are automatically generated;input limited to valid addresses(0...9, A...Z): Alpha-numeric input and special characters.IP - separating dots must be entered as special characters. The parameters illustrated above are only typical values.Addresses and settings may require different values for your network.