31UBI EasyCoder 101 – Technical ManualSETTING UP EASYCODER 101General Information The EasyCoder 101 is intended for applications, where the printingwill be controlled from a host computer and very little action isrequired by the operator. Accordingly, the printer is only fitted witha “Print” button, but no keyboard.The EasyCoder 101 is not delivered with more than one serialinterface.The method of changing the setup depends on whether the printeris fitted with some kind of startup file, a subject that was morethoroughly discussed in the chapter Starting Up earlier in thismanual. The alphabetic references below refer to that chapter.A. EasyCoder 101 with EasyPak Startup:• There is no Setup Mode in the EasyPak Startup program, butsome setup parameters can be changed from within UBI LabelShop,and – for the UBI Windows Driver – from “Control Panel/Printers” in Microsoft Windows.B. EasyCoder 101 with UBI Shell:• You can change any setup parameter via the Terminal Setupoption in UBI Shell.• You can change the printhead resistance and LSS setup via theSetup option of UBI Shell.• As an alternative, you can also change the setup by means of asetup file, see SETUP statement in the UBI Fingerprint manual.D. EasyCoder 101 with no startup file installed:• An EasyCoder 101 without any startup file can only be set up bymeans of setup files, see SETUP statement in the UBI Fingerprintmanual.E. EasyCoder 101 with a custom-made application program:• Normally, necessary provisions for changing the setup should beprovided by the program by means of setup files, see SETUPstatement in the UBI Fingerprint manual.