UBI EasyCoder 101 Technical Manual

Also see for EasyCoder 101: User guide Startup manual Install guide User guide Technical manual

Contents

UBI EasyCoder 101 Technical Manual Manual pdf 33 page image

33UBI EasyCoder 101 – Technical ManualSETTING UP EASYCODER 101 E & 101 SA, cont'd.Entering the Setup Modeat InstallationThe method of entering the Setup Mode depends on whether theprinter is fitted with some kind of startup file, a subject that wasmore thoroughly discussed in the chapter Starting Up earlier in thismanual, to which the alphabetic references below refer.A. EasyCoder 101 E with EasyPak Startup:• Turn on the power.• Select either the UBI LabelShop or the Windows Driver option.• Press the < Setup > key (in case of the Windows Driver, thismust be done before any data is received from the host).• Set up the printer as described in this chapter. In case of UBILabelShop, do not change the communication setup on "uart1:".• Return to the selected option by pressing the < Setup > key.B. EasyCoder 101 E with UBI Shell:• Turn on the power.• When the display shows the message “Print=UBI Shell; x sec.”,press < Enter >.• Press the < Setup > key (this facility can be used anywherewithin UBI Shell).• Set up the printer as described in this chapter.• Return to UBI Shell by pressing the < Setup > key.C. EasyCoder 101 SA:• Turn on the power.• In the Set Mode of the UBI Stand-Alone program, select the“Setup” option and then the “Printer” option.• Set up the printer as described in this chapter.• Exit to the UBI Stand-Alone program by pressing < Save >.D. EasyCoder 101 E with no startup file installed:• Turn on the power.• In the immediate mode of UBI Fingerprint, press the < Setup >key.• Set up the printer as described in this chapter.• Exit to the immediate mode of UBI Fingerprint by pressing the< Setup > key.E. EasyCoder 101 E with a custom-made application program:• Normally, there will be no need to enter the Setup Mode forcustom-made application programs. Necessary provisions forchanging the setup, manually or automatically, should be pro-vided by the program.