Tools for Configuring and Operating ï 63Configuring and Operating with WAGO-I/O-CHECKWAGO-I/O-SYSTEM 750I/O Modules4.1.1.3 NavigationYou can toggel between the different configuration areas of the module by us-ing the navigation on the left side of the screen (see Figure 22).Figure 22: Navigation between configuration areas g064431eChoose between the following menu items (see Table 25):Table 25: Navigation between configuration areas g064432e-36eMenu item Description[Settings]Opens a page with general module parameters such as device name, MACaddress, device role, etc. These parameters can be altered here and loadedto the module (see Section 4.1.1.5.1, "Settings").[Net Forming]Opens a page with device lists. Here, configured and bound deviceswithin range are displayed with MAC address and name and configured(see Section 4.1.1.5.2, "Net Forming").[PI Mapping]Opens a page for the allocation of slave process data to slots in the master(see Section 4.1.1.5.3, "PI Mapping").[Block Transfer]Opens a page for viewing the process data during uploading anddownloading. The menu entry "Block transfer" is only displayed in theconfiguration mode (see Section 4.1.1.5.4, "Block Transfer").[Diagnostics]Opens a page with comprehensive diagnostic information on the status ofthe module and the network as well as the connection quality (see Section4.1.1.5.5, "Diagnostics"). The menu entry "Diagnostics" is only displayedin the communication mode.
