wc_tx003580gb_FM10.fm104Mobile GeneratorOperation (Deep Sea Controller)9.7 Starting and Running the GeneratorProcedure Perform the procedure below to start the generator.1. Check the position of the voltage selector and make sure that it is set for thedesired voltage output. Lock the voltage selector in place.2. Set the main circuit breaker to the OFF “O” position.3. Set the convenience receptacle circuit breakers to the OFF “O” position.4. Set the genset controller power switch (a) to the ON “I” position.5. Press the “Manual mode” button (b).6. Press the “Start” “I” button (c).The LCD panel displays several screens as the start-up sequence begins.This procedure continues on the next page.CAUTIONPossibility of injury or equipment damage. Failure to match phase, voltage, andfrequency may cause equipment connected to the generator to operate incorrectly.► When using the generator as a stand-by or substitute power supply, make surethe phase, voltage, and frequency of the generator matches that of the utilitylines or of any other power source normally used.wc_gr011488acd bDisplay Meaning / DescriptionPreheating The engine is heating.Crank attempt The engine is attempting to start.
