wc_tx003579gb_FM10.fm65Mobile Generator Operation (Basler Controller)7.11 LCD Panel: Monitoring Machine OperationOverview Generator and engine information is continuously monitored and displayed on theLCD panel. The upper line displays generator information. The lower line displaysengine information.GeneratorinformationThe upper line of the LCD panel shows the voltage, phase, amperage, andfrequency of the electric power being generated. The information is shown onlywhen the engine is running.This procedure continues on the next page.wc_gr010202GeneratorEngineSymbol Meaning DescriptionV Volts Displays the value of the AC output voltage beingproduced by the generator.Ø Phase Displays the leg or phase currently being monitored. Inthree-phase mode, the display toggles between P1, P2,and P3. In single-phase mode, the display togglesbetween L1, L3, and L-L.A Amps Displays the value of the AC output amperageproduced by the generator. If the generator is operatingat no load, output amperage will be zero (0).HZ Frequency inHertzDisplays the value of the output frequency.For tier 3 engines, this display will read approximately61.5 Hz under a no-load condition and approximately60 Hz under load.For tier 4 engines, this display will read approximately60.0 Hz under no-load and loaded conditions.
