wc_tx003229gb_FM10.fm74Mobile GeneratorWorking with Basler Controller8.6 Adjusting the LCD Screen ContrastRequirements Machine stopped Start switch in REMOTE STARTNote: Internal programming of the genset controller, or closed connections to aremote start switch, may cause the machine to start unexpectedly. Be prepared forthe engine to start even with the engine start switch in the REMOTE STARTposition.Procedure Perform the procedure below to adjust the LCD screen contrast.1. Press the right arrow button (1) to access the MAIN MENU.2. Using the up/down arrow buttons (2, 3) highlight SETTINGS. Then, press theright arrow button.3. Highlight GENERAL SETTINGS. Then, press the right arrow button (1).4. Highlight FRONT PANEL HMI. Then, press the right arrow button.5. Highlight LCD CONTRAST. Then, press the check mark button (5).6. If you are not logged in, enter the password “OP”. Press the check mark button.7. Using the up/down arrow buttons, change the contrast value as desired. Pressthe check mark button when finished.8. Exit by pressing the left arrow button (4) twice or until the LCD displays theSETTINGS menu. Then, scroll to LOGOUT and press the check mark button.Press the left arrow button until the READY screen appears.Result The screen contrast has now been adjusted.
