wc_tx003548gb_FM10.fm138Mobile GeneratorDiagnostic Trouble Codes (DTC)14 Diagnostic Trouble Codes (DTC)14.1 Accessing DTCs with the Basler ControllerBackground This machine may include an engine that has self-diagnostic capabilities. Theseengines communicate issues with the engine through Diagnostic Trouble Codes(DTCs). When a DTC is present, an alert will show on the LCD panel display. ADTC is a two part code consisting of a Suspect Parameter Number (SPN), and aFailure Mode Identifier (FMI).Procedure Perform the procedure below to access Diagnostic Trouble Codes.1. At the READY screen, press the right arrow button (1) to bring up the MAINmenu.2. Highlight METERING. Then, press the right arrow button.3. Highlight ALARMS-STATUS. Then, press the right arrow button.4. Highlight J1939 ACTIVE DTC. Then, press the right arrow button.5. Highlight a DTC. Then, press the check mark button (5).Note: To access a past DTC, highlight J1939 PREV DTC. Then, press the rightarrow button.wc_gr01138223145 6METERINGSETTINGSMAIN MENUENGINEGENERATORPOWERRUN STATISTICSALARMS-STATUSDIAGNOSTICSMETERINGEVENT LOG 1J1939 DATAJ1939 ENGINE CONFIGJ1939 ACTIVE DTC 1J1939 PREV DTC 0ALARMS-STATUS1/1 SPN FMI OCJ1939 ACTIVE DTC 1100 4 1CLEAR DTCs NO175READY100% 13.4
