7878IndexContentsIndexContentsCALIBRATING INTUOS3 FOR AUTOCADIf you are using Intuos3 to digitize a drawing, you will need to calibrate Intuos3 with the paper drawing’scoordinate system. The calibration allows you to digitize points from the paper drawing into the appropriatecoordinate system of your drawing file.1. From the D RAWING EDITOR, open the TOOLS menu (OPTIONS menu for Release 13).2. Choose the T ABLET and C ALIBRATE options, then:• Digitize point #1 on the paper drawing. Then enter the xy coordinate from the paper drawing at thedigitized point.• Digitize point #2 on the paper drawing. Then enter the xy coordinate from the paper drawing at thedigitized point.• Digitize more points if necessary. More than four points may take more time than expected forAutoCAD to compute the best-fitting projective transformation.3. Press ENTER when you are done.When Intuos3 has been configured as a digitizer and calibrated, you can use C TRL+T to toggle betweenusing Intuos3 as a digitizer and as a Windows system pointer.
