2-2 Macintosh SetupbbTypically, only Macintosh computers are installed on an EtherTalk network. If youhave PCs operating in an EtherTalk network, see the documentation that came withyour PC EtherTalk interface.The following steps are required to set up your XANTÉ printer on an EtherTalk network.“Port Connection: Ethernet Port” earlier in this chapter covers step 1; the next twosections cover steps 2 and 3.1. Connect your XANTÉ printer to the network through the Ethernet port.2. Configure your Macintosh for EtherTalk. See the next section, “Configure theMacintosh for EtherTalk,” for details.3. Change the EtherTalk Zone name, if necessary using the Setzone.ps file andAdobe Downloader or via your browser. See “Change the EtherTalk ZoneName” later in this chapter for details.Configure the Macintosh for EtherTalkConfigure your connection through the AppleTalk Control Panel under Apple menu:Control Panels: AppleTalk on a Macintosh with OS 8.X or higher.• Go to the Apple menu, select Control Panels, and then select AppleTalk. SelectEthernet from the drop-down menu.Change the EtherTalk Zone NameOn an EtherTalk network with more than one zone, the network router assigns yourprinter a default zone. Check with your System Administrator to determine thecorrect zone for your printer. Then, if necessary, change the printer’s zone name usingthe Setzone.ps file and Adobe Downloader or the Set EtherTalk Zone option availablethrough your browser. See “Using Adobe Downloader” or see “Network (EtherTalk,General, and TCP/IP)” later in this chapter.Before Beginning Software Installation and ConfigurationBefore you begin software installation and configuration, be aware that installationdepends on your Macintosh OS version.• Any classic Macintosh OS version (not version X): When the XANTÉ UtilitiesCD-ROM is inserted into the computer, the setup program starts (or shouldstart) automatically.
