2-42 Macintosh Setupbb3. Check and change the following settings accordingly if necessary (fig. 2.92).a. Change the TCP/IP address Network Class if necessary (check with yourSystem Supervisor); then, click Change.b. Change the printer’s default TCP/IP address (Network and Node IDs) tothe address assigned by your System Supervisor by using the scroll arrowsbeside each number; then, click Change.c. Change the Subnet Mask if necessary; then, click Change. If you are usingDHCP, continue to step 4.d; otherwise skip to step 4.d. Select either DHCP On or DHCP Off and click Change.4. Close your browser; then, restart your printer to make the new TCP/IP addresstake effect.PostScript Features (AccelaFont, DPI, Linearization, LPI, Margins, More X-ACT, and VM)PostScript features include AccelaFont, DPI, Linearization, LPI, Margins, MoreX-ACT, and VM options.AccelaFontAccelalFont options allow you to set aside a portion of RAM disk to store fonts forquick system access. AccelaFont automatically loads the most recently used fonts fromthe printer’s optional hard disk into the RAM disk. This eliminates time usuallyrequired to access fonts from the hard disk.AccelaFont is active only if fonts are downloaded to an optional hard disk on theprinter and RAM Disk is enabled for 1 MB or more. Options are 0% through 100%(the factory default) in 10% increments.You also can set this feature using the front panel Utility: Font Accel configurationmenu.1. Go to the printer home page (fig. 2.93). See “Printer Home Page” earlier in thischapter for details.
