Phaser 4400 Laser Printer Service Manual 6-67RRP 6.3 Fuser Harness AssemblySee the Parts List on page 7-16.Warning: Switch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover (RRP 1.1 Left Interface Cover on page 6-6).3. Remove the Left Cover (RRP 1.2 Left Cover on page 6-7).4. Remove the Front Cover Assembly (RRP 1.6 Front Cover Assembly onpage 6-11).5. Remove the Left Front Cover (RRP 1.7 Left Front Cover on page 6-12).6. Remove the Left Plate (RRP 1.11 Left Plate on page 6-16).7. Remove the Plate Handle (RRP 1.12 Plate Handle on page 6-17).8. Open Rear Door.9. Remove the Fuser Assembly (RRP 6.2 Fuser Assembly on page 6-66).10.Remove the Top Cover Assembly (RRP 1.4 Top Cover Assembly on page 6-9).11.Remove the MPT Chute Assembly (RRP 4.1 MPT Chute Assembly on page 6-44).12.Remove the Paper Handler Assembly (RRP 5.1 Paper Handler Assembly onpage 6-57).13.Remove the Transport Chute Assembly (RRP 6.1 Transport Chute Assembly onpage 6-65).14.Remove the Print Cartridge Top Guide Assembly (RRP 7.2 Print Cartridge TopGuide Assembly on page 6-80).15.Remove the Engine Logic Board (RRP 9.3 Engine Logic Board on page 6-89).16.Remove the Main Motor Assembly (RRP 8.1 Main Motor Assembly onpage 6-84).17.Remove the Paper Feeder (RRP 3.1 Paper Feeder on page 6-28).18.Remove the Drive Gear Assembly (RRP 8.2 Main Drive Gear Assembly onpage 6-85).19.Unplug the P/JPRB (red) from the HVPS PWB (RRP 9.6 HVPS PWB onpage 6-92).20.Remove the screw that secures the HVPS Housing to the printer.21.Remove the HVPS.22.Pull the Fuser Harness Assembly from the left side of the printer.23.Remove the two screws that secure the Fuser Harness Assembly to the printer.24.Remove the Fuser Harness Assembly.