Operator Guide 1- 31Overview• If an exact match is found, the print job continues.• If an exact match is not found, the programmer can specify inthe job for the printer to do one of the following:– Stop printing the job and print an error sheet.– Print the data on an oversized sheet.If you encounter any problems related to paper sizing, contactyour lead operator or Xerox service representative.Long and short edge feedingTo feed through the printer, the leading edge of the paper must beat least 10 inches long. Therefore, the following standard sizes ofpaper must be loaded so that sheets feed long edge first:• 7 by 10 inch• B5• A4• US Letter• B4• US LegalThe following papers, which have long edges greater than 14.33inches / 364 mm must feed short edge first:• A3• US Ledger or US TabloidNOTE: JIS B4 can be fed either long edge or short edge first.Paper width and throughput speed (LCDS printing only)The width of the paper you use for your LCDS print job is directlyrelated to the rate at which the printer can print the job. The rate atwhich a job prints is called the “throughput speed” and ismeasured in pages per minute (ppm).NOTE: “Pages per minute” actually means “impressions perminute,” referring to one side of a printed sheet.A pitch is the amount of time the printer takes to image a page onthe photoreceptor belt. The term “pitch mode” refers to the numberof pitches that can occur during one complete photoreceptorrevolution. The pitch mode in which a specific job prints is basedon the paper size used for that job.The following table lists the pitch mode boundary values, paperwidths, and related printing speeds for the system. The chart
