TroubleshootingXerox ® VersaLink ® C7000 Color Printer 147User GuidePrinter Resets or Powers Off FrequentlyProbable Causes SolutionsThe power cord is not plugged into the outletcorrectly.Power off the printer, confirm that the power cord is plugged incorrectly to the printer and the outlet, then power on the printer.The power cord is not secured in placecorrectly.Use the bracket provided with the printer to secure the powercord in place.A system error occurred. Power off the printer, then power on again. Print the Error HistoryReport. For details, refer to Printing the Error History Report onpage 173. If the error persists, contact your Xerox representative.The printer is connected to an uninterruptiblepower supply.Power off the printer, then connect the power cord to a suitableoutlet.The printer is connected to a power stripshared with other high-power devices.Plug the printer directly into the outlet or into a power strip that isnot shared with other devices.Printer Does Not PrintProbable Causes SolutionsThe printer is in Power Saver mode. On the control panel, press the Power/Wake button.The printer has an error. If the Status LED is blinking amber, follow the instructions on thecontrol panel to clear the error. If the error persists, contact yourXerox representative.The printer is out of paper. Load paper into the tray.A toner cartridge is empty. Replace the empty toner cartridge.The drum cartridge has reached end of life.Note: In some cases, it is possible for theprinter to continue printing temporarily withthe Drum Cartridge Past End of Life messagedisplayed.Replace the drum cartridge.The toner waste container is full. Replace the toner waste container.No control panel indicators are lit. Power off the printer, confirm that the power cord is plugged incorrectly to the printer and the outlet, then power on the printer.If the error persists, contact your Xerox representative.The printer is busy. • If the Status LED is flashing blue, a previous print job could bethe problem.a. At your computer, use the printer properties to delete allprint jobs in the print queue.b. At the control panel, touch Jobs, then delete all pendingprint jobs.• Load the paper in the tray.• If the Status LED does not flash once after you send a printjob, check the connection between the printer and thecomputer. Power off the printer, then turn it on again.
