Troubleshooting148 Xerox ® VersaLink ® C7000 Color PrinterUser GuideProbable Causes SolutionsThe printer cable is disconnected. If the Status LED does not flash once after you send a print job,check the connection between the printer and the computer.There is a network-connectivity issue. If the printer is connected to a network:a. Verify that the Ethernet cable is connected to the printer.b. On the printer Ethernet connector, verify that the greenLED is On. If not, reseat both ends of the Ethernet cable.c. Examine the TCP/IP address in the Communication sectionof the Configuration Report. For details, refer to Printingthe Configuration Report on page 31.d. If the TCP/IP address is 0.0.0.0, the printer needs moretime to acquire an IP address from the DHCP server.Wait 2 minutes, then print the Configuration Report again.e. If the TCP/IP address is unchanged, or begins with 169,contact your network administrator.There is a wireless network setup orconnectivity issue.Verify that the Wireless Network Adapter is installed and properlyconfigured. For details, refer to Connecting to a Wireless Networkon page 35.Printing Takes Too LongProbable Causes SolutionsThe printer is set to a slower printing mode.For example, the printer is set to print onHeavyweight paper or Envelopes.It takes more time to print on certain types of special paper.Ensure that the paper type is set properly in the print driver and atthe printer control panel. For details, refer to Print Speed.The printer is in Power Saver mode. It takes time for printing to start when the printer is coming outof Power Saver mode.The way the printer was installed on thenetwork could be an issue.Determine if a print spooler or a computer sharing the printer isbuffering all print jobs and then spooling them to the printer.Spooling can slow print speeds. To test the speed of the printer,print some information pages such as the Demonstration Print.For details, refer to Information Pages. If the page prints at therated speed of the printer, there could be a network or printerinstallation issue. For more help, contact the systemadministrator.The job is complex. Wait. No action needed.The print-quality mode in the driver is set toEnhanced.Change the print-quality mode in the print driver to Standard.
