Regulatory InformationXerox ® VersaLink ® C7000 Color Printer 189User GuideTo enable Auto Power Off mode, contact your System Administrator. For details, refer to the SystemAdministrator Guide at www.xerox.com/office/VLC7000docs.To learn more about Xerox participation in sustainability initiatives, go to:www.xerox.com/about-xerox/environment/enus.html.Note: Changing the default Power Saver activation times can result in an overall higher energyconsumption of the device. Before you turn off Power Saver modes or set a long activation time,consider the increase in device power consumption.Default Power Saver SettingsThis device is ENERGY STAR®-qualified under the ENERGY STAR Program Requirements for ImagingEquipment. The transition time from Ready mode to Low-Power mode can be set up to 60 minutes.The default value is 10 minutes. The transition time from Low-Power mode to Sleep mode can be set upto 60 minutes. The default value is set at 1 minute. The total transition time from Ready mode to Sleepmode can take up to 60 minutes.To change the Power Saver settings, contact your system administrator or refer to System AdministratorGuide at www.xerox.com/office/VLC7000docs.Environmental Benefits of Duplex PrintingMost Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you toprint on both sides of the paper automatically, and therefore helps to reduce the use of valuableresources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires thaton models greater than or equal to 40 ppm color or greater than or equal to 45 ppm monochrome theduplex function has been auto enabled, during the setup and driver installation. Some Xerox modelsbelow these speed bands may also be enabled with 2-sided printing settings defaulted on at the time ofinstall. Continuing to use the duplex function will reduce the environmental impact of your work.However, should you require simplex/1-sided printing, you may change the print settings in the printdriver.Paper TypesThis product can be used to print on both recycled and virgin paper, approved to an environmentalstewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper(60 g/m²), which contains less raw material and thus save resources per print, may be used in certainapplications. We encourage you to check if this is suitable for your printing needs.
