Regulatory Information188 Xerox ® VersaLink ® C7000 Color PrinterUser GuideBasic RegulationsXerox has tested this printer to electromagnetic emission and immunity standards. These standards aredesigned to mitigate interference caused or received by this printer in a typical office environment.ENERGY STARThe ENERGY STAR program is a voluntary scheme to promote thedevelopment and purchase of energy efficient models, which help to reduceenvironmental impact. Details on the ENERGY STAR program and modelsqualified to ENERGY STAR can be found at the following website:www.energystar.gov.The ENERGY STAR and ENERGY STAR mark are registered United Statestrademarks.The ENERGY STAR Imaging Equipment Program is a team effort betweenUnited States, European Union, and Japanese governments and the officeequipment industry to promote energy-efficient copiers, printers, fax,multifunction printers, personal computers, and monitors. Reducing productenergy consumption helps combat smog, acid rain, and long-term changes tothe climate by decreasing the emissions that result from generating electricity.Power Consumption and Activation TimeThe amount of electricity that a device consumes depends on the way the device is used. This device isdesigned and configured to enable you to reduce your electricity usage.Power Saver modes are enabled on your device to reduce energy consumption. After the last print, thedevice transitions to Ready mode. In this mode, the device can print again immediately. If the device isnot used for a specified period, the device transitions to Low Power mode, then to Sleep mode. In thesemodes, to enable reduced-power consumption, only essential functions remain active. The device takeslonger to produce the first print after it exits the Power Saver modes than it takes to print in Readymode. This delay is the result of the system waking up and is typical of most imaging devices on themarket.To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is enabled,you can configure the mode as follows:• Always Allowed: The device powers off automatically after the specified time, and the cumulativeLow Power mode and Sleep mode timeouts have elapsed.• Allowed ONLY When Conditions are Met: The device automatically powers off only after timeoutshave elapsed. The device also powers off if USB Drive, and Wired and Non-Wired Network have notbeen activated.To change the Power Saver settings, refer to the User Guide at www.xerox.com/office/VLC7000docs.For further assistance, contact your System Administrator or refer to the System Administrator Guide.
