Installation and Setup36 Xerox® WorkCentre® 3655 Multifunction PrinterUser GuideConnecting to a Computer Using USBTo use USB, you must have Windows 7, Windows Server 2003, and later, or Macintosh OS X version 10.7and later.To connect the printer to the computer using a USB cable:1. Ensure that the printer is turned off.2. Connect the B end of a standard A/B USB 2.0 cable to the USB Port on the back of the printer.3. Attach the power cord and then plug in the printer and turn it on.4. Connect the A end of the USB cable to the USB Port on the computer.5. When the Windows Found New Hardware Wizard appears, cancel it.You are ready to install the print drivers. For details, see Installing the Software on page 40.Connecting to a Telephone LineNote: Not all options listed are supported on all printers. Some options apply only to a specificprinter model, configuration, operating system, or driver type.1. Ensure that the printer is turned off.2. Connect a standard RJ11 cable, No. 26 American Wire Gauge (AWG) or larger, to the Line port onthe back of the printer.3. Connect the other end of the RJ11 cable to an operating telephone line.4. Enable and configure the Fax functions.For details, see the System Administrator Guide at www.xerox.com/office/WC3655docs.Turning the Printer On and OffThis printer has both a power switch and a power button. The power switch on the side of the printercontrols the main power to the printer. The control panel power button controls power to the printerelectronic components. The preferred software-controlled printer shutdown method is to press the powerbutton.To turn on the printer:• Turn on the power switch.