Installation and SetupXerox® WorkCentre® 3655 Multifunction Printer 43User GuideInstalling Scan Drivers for Macintosh1. Insert the Software and Documentation disc into the appropriate drive on your computer.2. To view the .dmg file for your printer, double-click the disc icon on your desktop.3. Open the Scan Installer.dmg file, then navigate to the appropriate installer file for your operatingsystem.4. Open the Scan Installer package file.5. To acknowledge the warning and introductory messages, click Continue.6. To accept the license agreement, click Continue, then click Agree.7. Click Continue again.8. Enter your password, then click OK.9. If prompted to close other installations, click Continue Installing.10. To restart, click Log Out.Installing Drivers and Utilities for UNIX and LinuxXerox ® Services for UNIX Systems is a two part installation process. It requires the installation of aXerox ® Services for UNIX Systems code package and a printer support package. The Xerox ® Services forUNIX Systems code package must be installed before installing the printer support package.Note: You must have root or superuser privileges to perform the UNIX print driver installation onyour computer.1. At the printer, do the following:• Verify that both the TCP/IP protocol and the proper connector are enabled.On the printer control panel, do one of the following for the IP address:• Allow the printer to set up a DHCP address.• Enter the IP address manually.Print the Configuration Report and keep it for reference. For details, see Configuration Report on page26.2. At your computer, do the following:• Go to www.xerox.com/office/WC3655driversand select your printer model.From the Operating System menu, select UNIX, then click Go.Select the Xerox® Services for UNIX Systems package for the correct operating system. This package isthe core package and must be installed before the printer support package.To begin downloading, click the Start button.