2906. Under the NetWare data label, notice the Print Server name that is displayed. Use this name tocreate the Print Server on the NetWare Server. Log in passwords may also be set following theinstructions supplied in the Configure NetWare Settings procedure in the Internet Services sectionof this guide.7. Under the NetWare data label, determine if the IPX Frame Type is set for Auto sensing (the factorydefault). Other selections include Ethernet II (used when running TCP/IP on your network), Ethernet802.3 (used for NetWare versions up to 3.11), Ethernet 802.2 (the default for NetWare 3.12 andlater), and Ethernet SNAP (used on networks running TCP/IP and/or AppleTalk). If the Frame Typeis not set to Auto sensing, or to the specific frame type used by the Primary Server, configure theDevice with the correct Frame Type following the instructions supplied in the Configure NetWareSettings procedure in the Internet Services section of this guide.At the Windows workstation, perform these tasks:1. At your 95/98/Me/NT workstation verify that the correct protocol and service is installed.At the Desktop, right mouse click the Network Neighborhood icon ("My Network Places" in WindowsMe).Left mouse click on Properties.Click on the Protocols Tab (in Win. NT) or the Configuration Tab (in Win. 95/98/Me) to verify thatthe IPX/SPX Protocol has been installed. It should appear in the displayed list.Note: If the IPX/SPX Protocol has NOT been installed, click the Add button, select IPX/SPX Protocolfrom the available list and click OK. If the setup program fails to find the required files, you will haveto click Have Disk... to load the protocol from the Operating System installer disk for this workstation.Left mouse click on the Services Tab (in Win. NT) or the Configuration Tab (in Win. 95/98/Me) toverify that the Novell Client for NetWare (such as IntranetWare Client for Windows NT or NovellClient 32) is loaded. Do NOT use the Microsoft Client for NetWare because it is NOT NDS enabled.Note: If the Novell Client is not loaded you will need to load the Novell Client Service from the NovellServer Install CD ROM. Get the CD ROM, insert it in your ROM drive, and use Windows Explorer tolocate the Read Me file for your NetWare version. Follow the Read Me instructions to install theclient. When finished with the install, unless otherwise instructed by the Read Me file, you may stillhave to click on the Services Tab (NT) or Configuration Tab (95/98/Me), click the Add button, selectthe Novell client service, and click OK.
